Canon IR3300, IR2800, IR2200 manual Install, Toner-S, Strd-Pos

CHAPTER 5 SERVICE MODE

COPIER>FUNCTION>INSTALL

<INSTALL>

Use it as part of installation work.

TONER-S
	Use it to stir the toner inside the developing assembly.
Caution	•	Check to make sure that the developing assembly is securely mounted
	before pressing the OK key.
	•	Do not execute any operation. (The Stop key may be pressed.)
	Using the Mode
	1)	Select <TONER-S> to highlight; then, press the OK key.
	2)	The machine stirs toner (about 4 min), during which time a count-down
	is indicated to the right of <TONER-S> from 240 to 0.
	3)	The machine automatically stops after stirring toner.
STRD-POS
	Use it to execute automatic adjustment of the CCD read position in stream
	mode.
Caution	•	Execute this mode when installing the ADF or if you have removed and
	then installed the ADF once again.
	Using the Mode
	1)	Select <STRD-POS> to highlight; then, press the OK key.
	•	The machine executes automatic adjustment.
	2)	The machine stops operation automatically after adjustment.
	3)	The settings under COPIER>ADJUST>ADJ-XY>STRD-POS is up-
	dated. Record the new settings to the service label.
CARD
	Use it when installing the card reader.
	Using the Mode
	Enter the number of the card to use. 1 to 2701 (default: 1; as many as 300
	cards may be used starting with the entered number)
	Use it to initialize card control information:
	•	initializing the card names (group ID; starting with the entered number).
	•	initializing ID numbers for cards.

5-62 T COPYRIGHT © 2001 CANON INC. CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001