Canon IR3300, IR2800, IR2200 manual Adjusting the Registration for the Deck, F08-302-10, F08-302-11

CHAPTER 8 PAPER DECK-L1

3.2.7Adjusting the Registration for the Deck

If you must adjust the left/right registra-

tion (standard: 0 ±1.5 mm), perform the fol- lowing:

1)Sliding out the compartment. (p. 8-17P)

2)Using the two screws [2], change the position of the latch plate [1] of the deck open solenoid (SL2D) found at the left rear. (At this time, use the index [3] on the latch plate as a reference.)

3)Close the compartment, and check to make sure that the gap of the front cover is 3 ±1 mm.

4)If the gap is not 3 ±1 mm, adjust the front cover. (p. 8-19P)

[1] [3] [2]

F08-302-10

3.2.8 Adjusting the Position of the Support Member

If the compartment cannot be opened/ closed smoothly and the position of the sup- port roller must be adjusted, perform the following:

1)Remove the front cover. (p. 8-18P)

2)Using the four screws [4] of the roller support plate [3], make adjustments so that the support roller [1] and the floor

[2]is about 3 mm when the compart- ment is fully slid out. (At this time, use the scale [5] on the front side plate as a reference.)

	[5]
[4]	[4]

[3]

A

[1][2]

F08-302-11

COPYRIGHT © 2001 CANON INC. CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001 8-29 P