Canon IR3300, IR2800, IR2200 manual E002, E003, Copierfunctionfclearerr

	CHAPTER 6 SELF DIAGNOSIS
E002
0000	The temperature of the fixing film is as follows:
	1. has exceeded 100°C, but does not reach 115°C within 1 sec thereafter.
	2. has exceeded 140°C, but does not reach 150°C within 1 sec thereafter.
	3. has exceeded 160°C, but does not reach 165°C within 1 sec thereafter.
Main cause	The fixing film unit is faulty (i.e., the main thermistor TH1 has poor con-
	tact, or the fixing heater is faulty). The main power supply PCB is faulty.
	The DC controller PCB is faulty.
Caution	To clear the error, execute the following in service mode:
	COPIER>FUNCTION>FCLEAR>ERR.
Action	See the description for E003.
E003
0000	The main thermistor reading is lower than 140°C when paper is moved.
Main cause	The fixing film unit is faulty (i.e., the main thermistor (TH1) has poor con-
	tact or has an open circuit; or, the fixing heater is faulty). The main power
	supply PCB is faulty. The DC controller PCB is faulty.
Caution	To clear the error, execute the following in service mode:
	COPIER>FUNCTION>CLEAR>ERR.
Action
1. State
	Turn on the power switch, and clear E002/E003. Thereafter, turn off and
	then on the power switch. Does the fixing heater operate?
	NO: See “The fixing heater fails to operate.”
2. Wiring

Is the wiring from the DC controller PCB to the fixing film unit normal? NO: Correct the wiring.

3. Fixing film unit, DC controller PCB

Try replacing the fixing film unit. Is the problem corrected? YES: End.

NO: Replace the DC controller PCB.

COPYRIGHT © 2001 CANON INC. CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001 6-5 T