HP 1920-8G-PoE+ (180W) manual Mounting the switch on a workbench, Mounting the switch on a wall

Mounting the switch on a workbench

IMPORTANT:

•Reserve a clearance of 10 cm (3.9 in) around the chassis for heat dissipation.

•Do not place heavy objects on the switch.

To mount the switch on a workbench:

1.Verify that the workbench is sturdy and reliably grounded.

2.Place the switch bottom up, and clean the round holes in the chassis bottom with a dry cloth.

3.Attach the rubber feet to the four round holes in the chassis bottom.

4.Place the switch upside up on the workbench.

Figure 7 Attaching rubber feet (HP 1920-24G-PoE+ Switch)

Mounting the switch on a wall

Only the HP 1920-8G switch can be installed on a wall. The type of screws used to mount the switch on the wall depends on the wall type. This section uses a concrete wall as an example.

Wall-mounting anchor kits are user supplied. The screws must be a minimum of 3 mm (0.12 in) in diameter, and the screw head must be a minimum of 6 mm (0.24 in) in diameter.

Figure 8 Wall-mounting anchor kit

To install the switch on a concrete wall:

1.Drill two holes at the same height. Make sure the spacing in between is 160 mm (6.30 in), as shown in Figure 9.

The hole depth and diameter depend on the wall anchors and screws you use. Make sure you can push the anchors to their full depth in the holes.

7