HP 1920-16G, 1920-8G, 1920-48G, 1920-24G Connecting the console cable, Connecting the AC power cord

Figure 13 Installing the SFP transceiver module and optical fibers

Connecting the console cable

To connect a terminal (for example, a PC) to the switch:

1.Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.

2.Connect the DB-9 female connector of the console cable to the serial port of the PC.

3.Connect the RJ-45 connector to the console port of the switch.

Figure 14 Connecting the console cable

NOTE:

To disconnect the console cable, remove the RJ-45 connector of the cable and then the DB-9 female connector.

Connecting the AC power cord

1.Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.

2.Connect one end of the grounding cable to the grounding screw on the rear panel, and connect the other end to the ground.

3.Make sure the correct power source is used.

10