HP ProCurve 2500 Figure 8. Example of Isolating Ports on a Series 2500 Switch

Enhancements in Release F.05.05 through F.05.70

Enhancements in Release F.05.05 through F.05.60

1	1					2	3	4	5	6
				14
		13
	12					11	10	9	8	7
2
	1					2	3	4	5	6
14
13
	12					11	10	9	8	7
3	1					2	3	4	5	6
14
13
	12					11	10	9	8	7
4
	1					2	3	4	5	6
					14
			13
	12					11	10	9	8	7

		Port			Mode		Internal Traffic Destinations
							Allowed by Port Isolation Mode
1			- 3		Local		Each Other and Ports 10 - 12
4			- 8	Group1			Each Other and Ports 13 and 14
							(uplinks)
			9		Private		Gigabit Trunk (ports 13 & 14)
10			- 12		Public		Each Other, Ports 1 - 3, and the
							Uplink Ports.
13			- 14		Uplink		Ports 4 - 8 (group1), 9 (private), 10
							-12 (public)
5
				1		2	3	4	5	6
		14
	13
				12		11	10	9	8	7

This figure illustrates the port isolation example described in table 3 on page 26. Each switch view belongs to the same configuration and illustrates the indicated port set and the permitted communication for that set.

Configured	Other Port Set(s) Available to a
Port Set		Configured Port Set

Figure 8. Example of Isolating Ports on a Series 2500 Switch

Assuming a switch in the factory-default configuration, you would configure the port isolation plan in figure 8 as follows:

27