Entering One–Variable Data

1.Press ()to clear existing statistical data.

2.Key in each x–value and press .

3.The display shows n, the number of statistical data values now accumulated.

Pressing actually enters two variables into the statistics registers because the value already in the Y–register is accumulated as the y–value. For this reason, the calculator will perform linear regression and show you values based on y even when you have entered only x–data — or even if you have entered an unequal number of x–and y–values. No error occurs, but the results are obviously not meaningful.

To recall a value to the display immediately after it has been entered, press

.

￿Entering Two–Variable Data

If the data is a pair of variables, enter first the dependent variable (the 2nd variable of the pair) and press , and then enter the independent variable (the first variable of the pair) and press .

1.Press () to clear existing statistical data.

2.Key in the y–value first and press .

3.Key in the corresponding x–value and press .

4.The display shows n, the number of statistical data pairs you have accumulated.

5.Continue entering x, y–pairs. n is updated with each entry.

To recall an x–value to the display immediately after it has been entered, press

.

Correcting Errors in Data Entry

If you make a mistake when entering statistical data, delete the incorrect data and add the correct data. Even if only one value of an x, y–pair is incorrect, you must delete and reenter both values.