Caution

Note

Note

Connecting to Ethernet 10Base2 Network

Use the BNC port to connect the printer to an Ethernet 10Base2 network.

Make sure the printer is turned off before connecting to the BNC port.

Attach one section of your ThinLAN cable to the BNC “T” connector.

Attach another ThinLAN cable section or a 50-ohm terminator to the other side of the BNC “T” connector. If you are attaching the printer to the end of your network you must connect a 50-ohm terminator.

Connect the BNC “T” to the BNC port.

The 10Base-T port is the default port on the HP JetDirect 600N print server card.

The HP JetDirect 600N print server card supports one Ethernet cabling connection at a time.

EN

Getting Started Guide 21