HP 445 manual Defaultconfig boot Return, Press Y to commence the reboot operation

Installation

Phase 4: Initialize and Verify the Router

NCL prompt

Figure 1-25. The Default NCL Prompt

2.Boot the router (with your new configuration) by typing boot at the NCL prompt and pressing [Return].

DEFAULT_CONFIG: boot [Return]

3.If your router does not have a Manager password, go to step 4. But if the router has a previously set Manager password, you must enter the password before booting can proceed. In this case, the console prompts you to enter the password:

Enter current manager password:

Type your Manager password and press [Return]. (If you’ve forgotten the password and need to clear it, refer to ‘‘To Clear the Manager and User Passwords’’ on page 2-16.)

4.After you enter the Boot command (and enter a password, if required), the following message prompts you verify that you want to boot the router:

Do you want to reboot the system? [y/n]

Press [Y] to commence the reboot operation.

Installation 1

1-31