Stand
Description | Spare part number |
|
|
Stand | |
|
|
The stand is secured with four screws.
To remove the stand:
1.Prepare the computer for disassembly (see Preparing to Disassemble the Computer on page 43).
2.Remove the small rear cover (see Small Rear Cover on page 44).
3.Remove the port cover (see Port Cover on page 45).
4.In the order indicated by the numbers stamped into the stand bracket, remove the four Phillips screws (1) that secure the stand to the computer.
5.Slide the stand up (toward the logo) about 1 inch (2.5 cm) (2), tilt the stand base upward, and then slide it back (away from the logo) (3) to lift it out of the computer.
Figure
To replace the stand, reverse the removal procedures.
46 | Chapter 7 Removal and Replacement Procedures |