Table
Control panel message | Description | Recommended action | |
|
|
| |
Integrated graphics controller display cache | Replace system board if minimal graphics | ||
| is not working properly and will be disabled. | degrading is an issue. | |
|
|
| |
Computer cover was removed since last | No action required. | ||
Since Last System Startup | system startup. |
|
|
|
|
| |
Front audio harness has been detached or | Reconnect or replace front audio harness. | ||
| unseated from motherboard. |
|
|
|
|
| |
Front USB harness has been detached or | Reconnect or replace front USB harness. | ||
| unseated from motherboard. |
|
|
|
|
| |
Front USB harness has been detached or | Reconnect or replace front USB harness. | ||
| unseated from motherboard. |
|
|
|
|
| |
There is an incompatibility/problem with this | Try rebooting the system. If the error | ||
initialize | device and the system or PCI Express Link | reoccurs, the device may not work with this | |
| could not be retrained to an x1. | system | |
|
|
|
|
Both external and internal serial ports are | 1. | Remove any serial port expansion | |
| assigned to COM1. |
| cards. |
|
| 2. | Clear CMOS. (See Appendix B, |
|
|
| |
|
|
| |
|
| 3. | Reconfigure card resources and/or run |
|
|
| Computer Setup or Windows utilities. |
|
|
|
|
Both external and internal serial ports are | 1. | Remove any serial port expansion | |
| assigned to COM2. |
| cards. |
|
| 2. | Clear CMOS. (See Appendix B, |
|
|
| |
|
|
| |
|
| 3. | Reconfigure card resources and/or run |
|
|
| Computer Setup or Windows utilities. |
|
|
|
|
Both external and internal serial ports are | 1. | Remove any serial port expansion | |
| assigned to same IRQ. |
| cards. |
|
| 2. | Clear CMOS. (See Appendix B, |
|
|
| |
|
|
| |
|
| 3. | Reconfigure card resources and/or run |
|
|
| Computer Setup or Windows utilities. |
|
|
|
|
Hard drive is about to fail. (Some hard drives | 1. | Determine if hard drive is giving correct | |
Failure | have a hard drive firmware patch that will fix |
| error message. Enter Computer Setup |
| an erroneous error message.) |
| and run the Drive Protection System test |
|
|
| under Storage > DPS |
|
| 2. | Apply hard drive firmware patch |
|
|
| if applicable. (Available at |
|
|
| |
|
| 3. | Back up contents and replace hard |
|
|
| drive. |
|
|
| |
One or more SATA devices are improperly | Ensure SATA connectors are used in | ||
| attached. For optimal performance, the SATA | ascending order. For one device, use SATA | |
| 0 and SATA 1 connectors must be used | 0. For two devices, use SATA 0 and SATA 1. | |
| before SATA 2 and SATA 3. |
|
|
|
|
|
|
ENWW | POST Numeric Codes and Text Messages 49 |