Solution

In order for the printer to be usable on a network on which computers are protected by a software firewall, you must do the following:

1.Temporarily disable the software firewall before installing the printer software on a computer.

2.Assign the printer a static IP address.

Temporarily disabling the software firewall before installation

Before assigning the printer a static IP address and then installing the printer software on a computer, temporarily disable the software firewall on the computer. For instructions about disabling the software firewall, see the documentation that came with the software firewall.

Whenever the software firewall is disabled, HP strongly recommends that the following items be installed on the computer:

A hardware device, such as a gateway, that provides firewall protection between the computer and the Internet

An up-to-date anti-virus software program

For maximum virus protection while the firewall is disabled, disconnect the computer or router from the Internet while you install the printer software on the computer. After the printer software is installed, you can reconnect the computer or router to the Internet.

After disabling the software firewall, follow the steps for assigning the printer a static IP address.

Assign the printer a static IP address

Get ready

Before assigning the printer a static IP address, you must find the following information about the network:

The IP address range of the network DHCP server

Subnet mask

Gateway

To find this information, see the configuration utility for the network router or switch. Otherwise, see the documentation that came with the network router or switch.

The static IP address must be outside the range of IP addresses that the network assigns to devices on the network.

For example, a network might use DHCP to assign IP addresses that range from

10.0.0.1to 10.0.0.100. In this case, 10.0.0.25 would not be a good static IP address to assign to the printer since it falls in the range of IP addresses assigned by the network. However, 10.0.0.101 would be a good static IP address because it falls outside the range of IP addresses assigned by the network.

Network Guide

9

Page 11
Image 11
HP 6980 manual Solution, Assign the printer a static IP address Get ready