Remove the speakers:
1.Unsolder the top speaker cables (1) from the system board speaker connectors.
2.Unsolder the bottom speaker cables (2) from the system board speaker connectors.
NOTE: When installing the speakers, the red speaker cables should be soldered to the system
board “positive” terminals. The black speaker cables should be soldered to the system board “negative” terminals.
3.Remove the tape (3) that covers the bottom speaker.
4.Remove the Phillips PM1.2×4.5 screw (4) that secures the top speaker to the display panel assembly.
5.Remove the two Phillips PM1.6×4.1 screws (5) that secure the bottom speaker to the display panel assembly.
6.Remove the speakers (6).
7.Remove the speakers and cables. Reverse this procedure to install the speakers.
16 | Chapter 4 Removal and replacement procedures |
