Command Line Interface Reference Guide | vlan |
| |
Enter a list of protocols for the current VLAN delimited by commas.
protocols
■[no] vlan VLAN-ID protocol < IPX IPv4 IPv6 ... >
Set a predefined protocol for the current VLAN.
Supported Values:
■IPX -- IPX Protocol Group
■IPv4 -- IP version 4 Protocol Group
■IPv6 -- IP version 6 Protocol Group
■ARP -- Address Resolution Protocol Group
■Appletalk -- Appletalk Protocol Group
■SNA -- System Network Architecture Protocol Group
■NetBEUI -- Network BIOS Enhanced User Interface Protocol Group
proxy-arp
■[no] vlan VLAN-IDip proxy-arp
Usage: [no] ip proxy-arp
Description: Enable/disable proxy ARP. This is a VLAN context command.
It can be called directly from the VLAN context or may follow the 'vlan VLAN-ID' command prefix. When proxy ARP is enabled on a VLAN, the device responds to ARP requests received on the VLAN ports when the device knows a route to the requested IP addresses.
qos
■[no] vlan VLAN-IDqos
Usage: [no] qos [dscp <01...63af11af12af13af21af22af23af31af32
af33af41af42af43efcs0..cs7000000000001...111111> priority <0-7>]
Description: Set VLAN-based priority. The 'dscp' or 'priority' must be specified if 'no' is not used. Using 'no' configures the switch not to apply a VLAN priority override to this VLAN's packets.
This is a VLAN context command. It can be called directly from the VLAN context or follow the 'vlan VLAN-ID' command.
Next Available Options:
■dscp -- Specify DSCP policy to use. (p. 722)
■priority < 0 1 2 ... > -- Specify priority to use. (p. 742)
querier
■[no] vlan VLAN-IDip igmp querier
Usage: [no] ip igmp querier [interval <seconds>]
Description: Specify querier/non-querier capability for the VLAN. IGMP queries are not sent when the mode is disabled. When
