Command Line Interface Reference Guide

vlan

 

 

enabled, the device cannot become Querier for the subnet unless the VLAN has an IP Address (use the 'show ip' command to determine this). Each subnet must have at least one IGMP Querier-capable device in order for IGMP to function properly. The querier interval setting modifies the time (in seconds) between IGMP queries.

Next Available Option:

interval < 5 to 300 > -- Sets the interval in seconds between IGMP queries (default: 125) (p. 728)

[no] vlan VLAN-IDipv6 mld querier

Usage: [no] vlan < vid > ipv6 mld querier

Description: This command disables or re-enables the ability for the switch

to become querier if necessary. The no version of the command disables the querier function on the switch.

The show ipv6 mld config command displays the current querier command. (Default Querier Capability: Enabled.)

rapid-commit

[no] vlan VLAN-IDipv6 address dhcp full rapid-commit

Obtain IPv6 address quickly from DHCPv6 server.

reachable-time

[no] vlan VLAN-IDipv6 nd reachable-time

Usage: [no] ipv6 nd reachable-time <milliseconds>

Description: Configures the length of time neighbors are considered reachable after being confirmed as reachable via the neighbor unreachability detection algorithm. This value appears in router advertisements sent on this interface and

is also used to manage the neighbor table entries on this node.

Next Available Option:

number < 1000 to 3600000 > -- Configures the router lifetime sent in router advertisements(p. 738)

receive

vlan VLAN-ID ip rip receive < V1-only V2-only V1-or-V2 ... >

Define RIP version for incoming packets.

Supported Values:

V1-only-- Accept RIP version 1 updates only.

V2-only-- Accept RIP version 2 updates only.

V1-or-V2-- Accept both RIP 1 and RIP 2 updates.

disabled -- Do not accept RIP updates.

vlan VLAN-ID ip rip IP-ADDR receive < V1-only V2-only V1-or-V2 ... >

Define RIP version for incoming packets.

© 2009 Hewlett-Packard Development Company, L.P.

745