Removing a Hard Drive from a Drive Bay
NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive.
1.Prepare the computer for disassembly (Preparation for Disassembly on page 122)
2.Remove the access panel (Computer Access Panel on page 123)
3.Disconnect the power cable and data cable from the back of the hard drive.
4.Release the drive by pulling the release tab away from the drive (1) and sliding the drive out of the bay (2).
Figure
5.Remove the four guide screws (two on each side) from the old drive. You will need these screws to install a new drive.
Installing a Hard Drive into an Internal Drive Bay
NOTE: The system does not support Parallel ATA (PATA) hard drives.
1.Prepare the computer for disassembly (Preparation for Disassembly on page 122)
2.Remove the access panel (Computer Access Panel on page 123)
144 Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis