Power LED flashes Red four times, once every second, followed by a two second pause, and the computer beeps four times. (Beeps stop after fifth iteration but LEDs continue flashing.)

Cause

Solution

 

 

 

Power failure (power supply is overloaded).

1.

If equipped with a voltage selector, check that the

 

 

voltage selector, located on the rear of the power supply

 

 

(some models), is set to the appropriate voltage. Proper

 

 

voltage setting depends on your region.

 

2.

Open the access panel and ensure the power supply

 

 

cable is seated into the connector on the system board.

 

3.

Check if a device is causing the problem by removing

 

 

ALL attached devices (such as hard drives or optical

 

 

drives and expansion cards). Power on the system. If

 

 

the system enters POST, then power off and replace

 

 

one device at a time and repeat this procedure until

 

 

failure occurs. Replace the device that is causing the

 

 

failure. Continue adding devices one at a time to ensure

 

 

all devices are functioning properly.

 

4.

Replace the power supply.

 

5.

Replace the system board.

 

 

The incorrect external power supply adapter is being used on

The power supply adapter must be at the correct power

the All-in One or USDT.

rating and use the Smart ID technology before the system

 

will power up. Replace the power supply adapter with the

 

HP-supplied power supply adapter.

 

 

 

Solving Power Problems 259