2.Lift the touchpad from the computer (2).
3.Remove the touchpad.
Reverse this procedure to install the touchpad.
NOTE: When replacing the touchpad, make sure to install the screws into holes closer to the edge of computer.
Power connector
Description | Spare part number |
|
|
Power connector |
|
|
|
Before removing the power connector, follow these steps:
1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect the power from the computer by unplugging the power cord from the computer.
3.Disconnect all external devices from the computer.
4.Remove the battery (see Battery on page 40), and then remove the following components:
a.Hard drive cover (see Hard drive cover on page 45)
b.Hard drive (see Hard drive/SSD drive on page 46)
c.Service cover (see Service cover on page 51)
d.Keyboard (see Keyboard on page 58)
e.Base enclosure (see Base enclosure on page 61)
64 Chapter 4 Removal and replacement procedures
