Operation
Operation
Basic Operations
1Make the necessary connections before pro- ceeding. Connect the power cord to a wall outlet. The POWER indicator illuminates red and the projector enters standby mode.
•If the bottom filter cover is not securely installed, the POWER indicator flashes.
2Press Power ON.
2
•The flashing green LAMP REPLACEMENT indicator shows that the lamp is warming up. Wait until the indicator stops flashing before operating the projector.
•If the power is turned off and then immediately turned on again, it may take a short while before the lamp turns on.
•If the keylock level is set to “Level A” or “Level B”, Power ON and Power OFF can only be used on the remote control. (See page 43.)
•After the projector is unpacked and turned on for the first time, a slight odor may be emitted from the exhaust vent. This odor will soon disappear with use.
When the power is on, the LAMP REPLACEMENT indicator lights indicating the status of the lamp. Green: Lamp is ready.
Flashing green: Warming up.
Red: Change the lamp.
