Sharp XG-C40XU operation manual Connecting RS-232C Port, Connecting the Projector

Connecting the Projector

Connecting RS-232CPort

When the RS-232C port on the projector is connected to a computer with an RS-232C cable (null modem, cross type, sold separately), the computer can be used to control the projector and check the status of the projector. See pages 55 and 56 for details.

Computer RGB cable
QCNWG0002CEZZ	DIN-D-sub RS-232C
	cable
Computer audio cable	QCNW-5288CEZZ
QCNW-4870CEZZ

1Connect the supplied DIN-D-sub RS-232C cable to the RS-232C port on the projector.

2Connect an RS-232C cable (null modem, cross type, sold separately) to the other end of DIN-D-sub RS- 232C cable and to the serial port on the computer.

	2 RS-232C cable	1 DIN-D-sub
(null modem, cross type, sold separately)		RS-232C cable

CAUTION

•Do not connect or disconnect an RS-232C cable to or from the computer while it is on. This may damage your computer.

•The wireless mouse or RS-232C function may not operate if your computer port is not correctly set up. Please refer to the operation manual of the computer for details on setting up/installing the correct mouse driver.

•The arrows (→, ↔) indicate the direction of the signals.

•A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Authorized Sharp Industrial LCD Products Dealer or Service Center.

Setup & Connections

E-16