Sharp XG-C40XU operation manual Connecting the Projector, Connecting the Power Cord

Connecting the Projector

Connecting the Power Cord

Plug the supplied power cord into the AC socket on the back of the projector.

Power cord

CACCU0106DE01

Connections&

Setup

Connecting the Projector to a Computer

You can connect your projector to a computer for projection of full color computer images.

To a computer using the standard 15-pin input

Computer RGB cable

QCNWG0002CEZZ

Computer audio cable

QCNW-4870CEZZ

1 Connect one end of the supplied computer RGB cable to the INPUT 1 or 2 port on the projector.

2 Connect the other end to the Monitor output port on the computer. Secure the connectors by tightening the thumb screws.

3 To use the built-in audio system, connect one end of the supplied computer audio cable to the AUDIO INPUT terminal for INPUT 1, 2 on the projector.

4 Connect the other end to the Audio output terminal on the computer.

CAUTION

• Before connecting, be sure to turn both the projector and the computer off. After making all connections, turn the projector on first. The computer should always be turned on last.

• Please read the computer’s operation manual carefully.

• Refer to page 57 “Computer Compatibility Chart” for a list of computer signals compatible with the projector. Use with computer signals other than those listed may cause some of the functions not to work.

When connecting this projector to a computer, select “Computer/RGB” for “Signal Type” on the GUI menu. (See page 29.)

• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Authorized Sharp Industrial LCD Products Dealer or Service Center.

E-13