HP C7280, C7250, C7288 manual To set up the HP All-in-One with DSL

Chapter 3

Figure 3-2 Back view of the HP All-in-One

1Telephone wall jack

2DSL filter and cord supplied by your DSL provider

3Use the phone cord supplied in the box with the HP All-in-One to connect to the "1-LINE" port

To set up the HP All-in-One with DSL

1.Obtain a DSL filter from your DSL provider.

2.Using the phone cord supplied in the box with the HP All-in-One, connect one end to your telephone wall jack, then connect the other end to the port labeled 1-LINE on the back of the HP All-in-One.

NOTE: If you do not use the supplied cord to connect from the telephone wall jack to the HP All-in-One, you might not be able to fax successfully. This special phone cord is different from the phone cords you might already have in your home or office.

3.Connect the DSL filter cord to the telephone wall jack.

NOTE: If you have other office equipment or services attached to this phone line, such as a distinctive ring service, answering machine, or voice mail, see the appropriate section in this section for additional setup guidelines.

4.Run a fax test.

Case C: Set up the HP All-in-One with a PBX phone system or an ISDN line

If you are using either a PBX phone system or an ISDN converter/terminal adapter, make sure you do the following:

Fax setup

24 Fax setup