HP C7250 Print the wireless network test, Set link speed, Automatic Full Half, Change IP settings

3.Press until Wireless Radio is highlighted, and then press OK.

4.Press to highlight On or Off, and then press OK.

Print the wireless network test

The wireless network test performs a series of diagnostic tests to determine whether network setup is successful. The wireless network test prints automatically when the Wireless Setup Wizard is run. You also can print the wireless network test at any time.

1.On the control panel of the HP All-in-One, press Setup.

2.Press until Network is highlighted, and then press OK.

3.Press until Wireless Network Test is highlighted, and then press OK. The Wireless Network Test prints.

Change advanced network settings from the control panel settings

The advanced network settings are provided for your convenience. However, unless you are an advanced user, you should not change any of these settings.

Set link speed

You can change the speed at which data is transmitted over the network. The default is Automatic.

1.Press Setup.

2.Press until Network is highlighted, then press OK. The Network menu appears.

3.Press until Advanced Setup is highlighted, and then press OK. Press until Set Link Speed is highlighted, and then press OK.

4.Press to select the link speed that matches your network hardware, and then press OK to confirm the setting.

•Automatic

•10-Full

•10-Half

•100-Full

•100-Half

Change IP settings

The default setting for the IP settings is Automatic, which sets the IP settings automatically. However, if you are an advanced user, you might want to manually change the IP address, subnet mask, or the default gateway. To see the IP address and subnet mask of the HP All-in-One, print a network configuration page from the HP All-in-One.

NOTE: When manually entering an IP setting, you must already be connected to an active network, otherwise the setting will not stay when you exit from the menu.

CAUTION: Be careful when manually assigning an IP address. If you enter an invalid IP address during the installation, your network components will not be able to connect with the HP All-in-One.

1.Press Setup.

2.Press until Network is highlighted, then press OK. The Network menu appears.

Network setup

Manage your network settings 19