HP Cloud Network Manager Software LDAP Server

Data pane item	Description
SHARED KEY	Enter a shared key for communicating with the external RADIUS server.
RETYPE	Re-enter the shared key.
SHARED KEY
TIMEOUT	Specify a timeout value in seconds. The value determines the timeout for one
	RADIUS request. The AP retries to send the request several times (as configured in
	the Retry count), before the user is disconnected. For example, if the Timeout is 5
	seconds, Retry counter is 3, user is disconnected after 20 seconds. The default
	value is 5 seconds.
RETRY COUNT	Specify a number between 1 and 5. Indicates the maximum number of
	authentication requests that are sent to the server group. The default value is 3
	requests.
RFC 3576	Select Enabled to allow the APs to process RFC 3576-compliant CoA and
	disconnect messages from the RADIUS server. Disconnect messages terminate
	the user session immediately, whereas the CoA messages modify session
	authorization attributes such as data filters.
NAS IP ADDRESS	Enter the VC IP address. The NAS IP address is the VC IP address that is sent in
	data packets.
	NOTE: If you do not enter the IP address, the VC IP address is used by default
	when Dynamic RADIUS Proxy (DRP) is enabled.
NAS IDENTIFIER	Use this to configure strings for RADIUS attribute 32, NAS Identifier, to be sent with
	RADIUS requests to the RADIUS server.
DEAD TIME	Specify a dead time for authentication server in minutes.
	When two or more authentication servers are configured on the AP and a server is
	unavailable, the dead time configuration determines the duration for which the
	authentication server is available if the server is marked as unavailable.
DYNAMIC RADIUS	Specify the following dynamic RADIUS proxy parameters:
PROXY
PARAMETERS	• DRP IP — IP address to be used as source IP for RADIUS packets.
	• DRP MASK — Subnet mask of the DRP IP address.
	• DRP VLAN — VLAN in which the RADIUS packets are sent.
	• DRP GATEWAY — Gateway IP address of the DRP VLAN.
	For more information on dynamic RADIUS proxy parameters and configuration
	procedure, see Configuring dynamic RADIUS proxy parameters on page 51.

nLDAP Server —To configure an LDAP server, specify the attributes described in the following table:

Table 22: LDAP server configuration parameters

Data pane item	Description
NAME	Enter the name of the LDAP server.
IP ADDRESS	Enter the IP address of the LDAP server.
AUTH PORT	Enter the authorization port number of the LDAP server. The default port number is
	389.

HP Cloud Network Manager User Guide Wireless configuration 50