OPERATION
4.Select cleaning method by pressing restorative/ interim cleaning switch (Figure 11).
FIG. 11
Restorative Cleaning Method: The machine operates at a slower set speed to restore heavily soiled carpet areas. The restorative cleaning method must be performed on a regular basis in order for the interim cleaning method to be effective.
Interim Cleaning Method: Machine operates at faster set speed for routine light cleaning. The interim cleaning method will be ineffective if the restorative cleaning method is not performed on a regular basis.
5.Rotate control grips completely forward to begin cleaning (Figure 12).
WARNING: Flammable materials or reactive metals can cause explosion or fire. Do not pick up.
NOTE: Machine travel speed for the cleaning modes are set speeds.
FIG. 12
6.View brush pressure meter while operating. Meter should read center of green zone (Figure 13). If brush height adjustment is required, see
ADJUSTING BRUSH HEIGHT.
FIG. 13
7.To operate machine in reverse, raise brush lever and pull reverse drive trigger (Figure 14).
FIG. 14
8.To stop cleaning, release control grips. Raise brush lever and turn off machine.
9.After cleaning carpet, allow 3 to 4 hours for carpet to dry. Use air movers to reduce drying time.
WHILE OPERATING MACHINE
WARNING: Flammable materials or reactive metals can cause explosion or fire. Do not pick up.
1.Periodically check for foam buildup in recovery tank (look through clear dome). If excessive foam buildup begins to develop, pour a recommended foam control solution into recovery tank.
ATTENTION: Do not allow foam or water beyond ªFULL LINEº label, located on standpipe, vacuum motor damage will result. Vacuum motor damage due to foam or water is not covered by warranty.
2.Overlap each pass by about 51 mm (2 in).
3.Keep machine within 152±203 mm (6±8 in) of baseboard.
4.When turning, it may be necessary to turn pump switch off and raise brush lift lever.
8
Home Find... Go To..
Concorde HP Plus (01±00)