OPERATION

5.Before reaching end of cleaning path, turn pump switch off and continue to drive machine forward to extract solution.

6.Drain recovery tank when recovered water reaches ªFULL LINEº label, located on standpipe in recovery tank (See DRAINING TANKS).

7.Observe gallon marker for remaining cleaning solution.

8.Periodically check battery meter discharge level. Recharge batteries when discharged below half.

9.When solution tank runs dry, turn off pump and vacuum switches, raise brush and transport machine to draining area (See DRAINING TANKS).

10.If cleaning path leaves streaks, spray tip cleaning is required (See SPRAY BAR AND SPRAY TIP MAINTENANCE).

11.If machine is left unattended, turn off machine and pull out main circuit breaker button.

FOR SAFETY: Before leaving or servicing machine, stop on level surface, turn off machine and pull out main circuit breaker button.

CIRCUIT BREAKER PANEL

The machine is equipped with (3) resetable circuit breakers to protect machine from damage, (labeled as brush, main and drive). They stop current flow when circuit overload occurs. Once a circuit breaker has tripped, determine problem, let motor cool down and manually reset breaker by pressing circuit breaker button. The vacuum motors are thermally protected and will automatically shut±off when an overload occurs. The main and drive circuit breakers are designed so you can stop current flow by manually pulling out circuit breaker buttons. Pull out the main circuit breaker button when servicing machine or when machine is left unattended. Circuit breaker buttons are located at rear of machine as shown (Figure 15).

FIG. 15

ADJUSTING BRUSH HEIGHT

1. Turn all switches off.

FOR SAFETY: Before leaving or servicing machine, stop on level surface, turn off machine and pull out main circuit breaker button.

2.Disengage brush lift lever from lock block (Figure 16).

FIG. 16

3.Locate adjustment knobs on adjustment shaft and loosen bottom knob (Figure 17).

FIG. 17

4.Turn upper knob clockwise to lower brush and counterclockwise to raise.

5.Tighten down bottom knob after adjusting.

Concorde￿ HP Plus (01±00)

Home

 

Find...

 

Go To..

 

9