OPERATION

4.Connect cables to battery posts in numerical order as labeled (RED to POSITIVE & BLACK to NEGATIVE). Cover post with rubber boot (Figure 3).

4 BLK

2(±)

1

3

RED (+)

FIG. 3

5.Double check cable connections before closing up battery compartment.

6.Replace hood and reset the main circuit breaker button.

7.Turn main power switch on, and check battery meter charge level to ensure batteries are fully charged. If batteries need charging, see

BATTERY CHARGING.

MACHINE SETUP

FILLING SOLUTION TANK

1.Transport machine to filling station (See

MACHINE OPERATION).

2.Fill solution tank with 113.5 L (30 gal) of clean water at fill port, 60° C (140° F) maximum temperature. Use gallon markers on side of tank to indicate fill level (Figure 4).

FIG. 4

3.Add recommended cleaning chemical. Use proper dilution ratio instructions on bottle.

FOR SAFETY: When using machine, follow mixing and handling instructions on chemical containers.

WARNING: Flammable materials can cause an explosion or fire. Do not use flammable materials in tank(s).

ATTENTION: Use only recommended cleaning chemicals, DO NOT use substitutes. Consult an authorized distributor to assist you with the recommended cleaning chemicals.

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless operator manual is read and understood.

PRE±OPERATION CHECKS

1.Vacuum floor and remove debris.

2.Check battery meter charge level; machine should be fully charged prior to using. Do not operate machine if batteries are discharged below half (See BATTERY CHARGING).

3.Check that recovery tank standpipe screen is in place.

4.Check that spray bar is installed (See SPRAY BAR AND SPRAY TIP MAINTENANCE).

5.Check that inline strainer filter is installed (See

SOLUTION FILTERS MAINTENANCE).

6.Inspect spray tips for proper spray pattern (See

SPRAY BAR AND SPRAY TIP MAINTENANCE).

TRANSPORTING MACHINE

Operating machine without using cleaning functions.

1.Raise brush lift lever and engage lock block.

2.Activate main power switch.

3.Press drive switch towards transport mode symbol (Figure 5).

NOTE: If filling with a bucket be certain that bucket is clean. This will prevent possible solution line clogs.

6

Home Find... Go To..

Concorde￿ HP Plus (01±00)