Simple set-yp Instructlom- \
GETTING STARTED
1.After the batteries are installed, your next step is to set up the codes for each component you wish to operate. (YOUR COMPONENT WILL NOT OPERATE WITH THE REMOTE UNTIL ITS CODE IS SET UP.)
2.In the space below, write the brands and codes of each of your remote controlled components.
ComDonent Brand Code(s)
TV~___
VCR1
VCR2~~
Cable Box | ~ | ~ |
Audio
Component
3.Find the codes for each brand on the charts following these instructions.
Code Listings
ComDonentm
TV |
| 6 |
VCR |
| 7 |
Cable | Box | 8 |
Audio | Components | 9 |
Since there may be more than one code listed for your brand of TV, VCR, Cable Box or Audio Component, note all the codes listed.
SETTING UP YOUR CODES
Set up each component using steps 4- 8 below. Repeat the steps for each component you intend to operate with the remote control.
Press the component button on the remote that matches the component you want to set up (TV, VCRl, VCR2, Cable or Audio).
Press the ID button (The ID button is located above the No. 3
key).
Within three seconds of pressing the ID button, use the
7.Point the remote at the component you want to operate and press the ON/OFF button. If it turns on, you are ready to set up your next component. For easy reference, circle the code in the chart on the left that turned on your component.
8.If the component does not turn on, repeat steps
Please Note: If none of the codes for your device work, try all codes starting with 00. Since some of the brands include products made by a variety of manufacturers, the code may be listed under another brand name.
..... .., | . |