Power and Signal Distribution

7.2.2 Power Control

The power supply assembly is controlled digitally by the PS On signal (Figure 7-1). When PS On is asserted, the Power Supply Assembly is activated and all voltage outputs are produced. When PS On is de-asserted, the Power Supply Assembly is off and no voltages (except +5 AUX) are generated. Note that the +5 AUX voltages are always produced as long as the system is connected to a live AC source.

Power Button

The PS On signal is typically controlled through the Power Button which, when pressed and released, applies a negative (grounding) pulse to the power control logic. The resultant action of pressing the power button depends on the state and mode of the system at that time and is described as follows:

System State

Pressed Power Button Results In:

Off

Negative pulse, of which the falling edge results in power control logic

 

asserting PS On signal to Power Supply Assembly, which then initializes. ACPI

 

four-second counter is not active.

 

 

On, ACPI Disabled

Negative pulse, of which the falling edge causes power control logic to

 

de-assert the PS On signal. ACPI four-second counter is not active.

 

 

On, ACPI Enabled

Pressed and Released Under Four Seconds:

 

Negative pulse, of which the falling edge causes power control logic to

 

generate SMI-, set a bit in the SMI source register, set a bit for button status,

 

and start four-second counter. Software should clear the button status bit within

 

four seconds and the Suspend state is entered. If the status bit is not cleared

 

by software in four seconds PS On is de-asserted and the power supply

 

assembly shuts down (this operation is meant as a guard if the OS is hung).

 

Pressed and Held At least Four Seconds Before Release:

 

If the button is held in for at least four seconds and then released, PS On is

 

negated, de-activating the power supply.

 

 

7-4

361834-002

Technical Reference Guide