HP dc7800 manual Network Interface Controller, Lan I/F Nic

Input/Output Interfaces

5.10 Network Interface Controller

These systems provide 10/100/1000 Mbps network support through an Intel 82566 network interface controller (NIC), a PHY component, and a RJ-45 jack with integral status LEDs. The 82562-equivalent controller integrated into the 82801 ICH component is not used (disabled) in these systems. (Figure 5-11). The support firmware for the BCM5752 component is contained in the system (BIOS) ROM. The NIC can operate in half- or full-duplex modes, and provides auto-negotiation of both mode and speed. Half-duplex operation features an Intel-proprietary collision reduction mechanism while full-duplex operation follows the IEEE 802.3x flow control specification.

LED

Green Yellow

		Green LED			RJ-45
				Connector
Intel	Tx/Rx Data
			Tx/Rx Data
82566		LAN I/F
NIC
		Yellow LED

Function

Activity/Link. Indicates network activity and link pulse reception. Speed: Off = 10 Mb/s, yellow = 100Mb/s, green = 1 Gb/s.

Figure 5-11. Network Interface Controller Block Diagram

The Network Interface Controller includes the following features:

■VLAN tagging with Windows XP and Linux

■Multiple VLAN support with Windows XP

■Power management support for ACPI 1.1, PXE 2.0, WOL, ASF 1.0, IPMI, AMT 3.0

■Cisco Etherchannel support

■Link and Activity LED indicator drivers

The controller features high and low priority queues and provides priority-packet processing for networks that can support that feature. The controller's micro-machine processes transmit and receive frames independently and concurrently. Receive runt (under-sized) frames are not passed on as faulty data but discarded by the controller, which also directly handles such errors as collision detection or data under-run.

The NIC uses 3.3 VDC auxiliary power, which allows the controller to support Wake-On-LAN (WOL) and Alert-On-LAN (AOL) functions while the main system is powered down.

✎For the features in the following paragraphs to function as described, the system unit must be plugged into a live AC outlet. Controlling unit power through a switchable power strip will, with the strip turned off, disable any wake, alert, or power mangement functionality.

5-16 www.hp.com Technical Reference Guide