HP dx7300 manual Enww

6.Remove the drive bezel by pressing inward on all the tabs on the left, right, and bottom of the drive bezel (1) and pushing the drive bezel out of the larger front bezel (2).

NOTE The type of bezel will vary depending on the computer configuration.

Figure 2-29Removing a Drive Bezel (Diskette Drive Bezel shown)

7.Replace the removed drive bezel with the appropriate bezel by pushing the bezel into place.

Figure 2-30Installing a Drive Bezel (Bezel Blank for Hard Drive shown)

NOTE The type of bezel you need will depend on the type of drive you plan to install. If you are installing a diskette drive, you must install a diskette drive bezel (PN 360189-001). If you are installing a hard drive, you must install a bezel blank (PN 358797-001). If you are installing a 3.5-inch drive other than a diskette drive or hard drive, such as a media card reader, you must install the 3.5-inch optional device drive bezel (PN 358796-001). Contact an authorized HP reseller or service provider to order the appropriate bezel when reconfiguring the computer.

8.Replace the computer cover.

9.If the computer was on a stand, replace the stand.

36 Chapter 2 Hardware Upgrades ENWW