Replacing a switch
In this section |
|
Replacing an existing switch | 26 |
Replacing an existing switch
CAUTION: Removing the switch from a powered enclosure results in the loss of network communications between the server blade network ports that are connected through this switch and the segment of network infrastructure those ports need to communicate.
For continued blade server network communication and services availability before removing the switch, redirect critical
CAUTION: Do not cable the switch until after configuration.
To replace an existing switch:
1.Save the configuration file to a TFTP server for later retrieval. For more information on saving a configuration file to a TFTP server, see the HP 1:10Gb Ethernet
2.Remove and label the cables.
3.Remove the switch.
4.Slide the new switch fully into the interconnect bay. For more installation information, see "Installing the switch (on page 21)."
Replacing a switch 26