HP ML330 manual Internal Drive Support, Ports, Deployment/Serviceability

QuickSpecs

HP ProLiant ML330 Generation 6

Overview

One Quad-Core/Dual Core Intel® Xeon® W3500 processors

Intel® 5500 chipset Memory:

18 DIMM slots

Up to 192GB, using PC3-8500R DDR3 Registered (RDIMM) memory, operating at 800MHz when fully populated at 3 DIMMs per Channel in 18 slots.

Up to 48GB, using PC3-10600E DDR3 Unbuffered (UDIMM) memory, operating at 1066MHz when fully populated at 2 DIMMs per Channel in 12 slots.

NOTE: If only one processor is installed, only half the DIMM slots are available Storage Controllers:

Entry Models: Non hot plug model with embedded HP Smart Array B110i SATA RAID Controller (RAID 0/1/1+0) o Base Models: Hot plug SAS/SATA model (SAS model integrated HP Smart Array P410/Zero memory SAS Controller (RAID 0/1/1+0)

Performance Models: Hot plug SATA model integrated HP Smart Array B110i SATA RAID controller hot plug advanced key

Available upgrades: 256MB, 512MB/1G with write back, Battery kit upgrade (for FB/BBWC), and Smart Array Advanced Pack (SAAP)

Internal Drive Support:

Up to eight (8) LFF (3.5") Hot Plug or four (4) Non Hot Plug Serial Attached SCSI (SAS) or Serial-ATA (SATA) hard drives

Maximum of 16TB of internal storage capacity Network Controller:

Embedded NC326i PCI Express Dual Port Gigabit Server Adapter Expansion Slots:

Four total expansion slots

One (1) PCI-Express x8 Gen1 (x1 speed); One (1) PCI-Express x16 Gen2 (x16 speed); Two (2) PCI-Express x8 Gen2 (x4 speed)

Optional PCI-X Expander provides additional two (2) 64-bit/100-MHz PCI-X slots by using a single PCI Express slot (only on slot 5)

Ports:

USB 2.0 support

Eight total ports: (2) front; (4) rear; (2) internal (1 for Tape)

1 internal Secure Digital (SD) slot Power Supply:

One 460 W Non-Hot Plug, Non-redundant Power Supply

Optional 750W Hot Plug redundant power supply

NOTE: The 750W power supply requires RPS Enablement kit. Redundancy:

Optional Hot plug redundant power supply

Optional for optional redundant fan Infrastructure Management:

HP Integrated Lights-Out 2 (iLO 2) management processor for simplified server setup, health monitoring and recovery, power and thermal control, and lights-out remote administration.

HP Insight Control a product option, delivers essential infrastructure management that can help save time and money by making it easy to deploy, migrate, monitor, control and optimize your IT infrastructure through a single, simple management console. Insight Control supports both Windows and Linux-based central management servers.

HP Insight Dynamics for ProLiant, a product option, is an integrated command center that enables IT Staff personnel to continuously analyze and optimize a converged infrastructure, while automating and reducing the cost of common data center tasks by as much as 40 percent. This ultimately enables them to dynamically keep pace with the organization's changing business requirements.

Deployment/Serviceability:

Easy chassis entry and component access

Customer Self Repair (CSR): HP products are designed with many CSR parts to minimize repair time and allow for greater flexibility in performing defective parts replacement

HP Smart Start Tool

Operating Systems and Virtualization Software Support for ProLiant Servers:

Supports Windows, RHEL, SLES, OEL, VMware, and HP Citrix Essentials for XenServer

DA - 13361 Worldwide QuickSpecs — Version 17 — 3-31-2010 Page 2