Troubleshooting

Troubleshooting (Continued)

Problem

Solutions

 

 

Lamp shuts off.

1. If the Standby LED flashes green,

 

the projector has overheated and

 

will automatically shut down. Wait

 

five to ten minutes until the LED

 

stops flashing and the

 

Power/Standby button turns amber

 

before restarting the projector again.

 

2. A minor power surge may cause the

 

lamp to shut off. Wait a few minutes,

 

then turn it back on.

 

3. When the lamp has reached the end

 

of its life, the system will

 

automatically turn off to prevent

 

possible lamp rupture. Replace the

 

lamp as described in the “Replacing

 

the Projector Lamp Module” section

 

of Chapter 7.

 

 

Lamp burns out or makes a

When the lamp reaches its end of life, it

popping sound.

will burn out and may make a loud

 

popping sound. If this happens, the

 

projector will not turn back on until the

 

lamp module has been replaced.

 

Contact your local Compaq authorized

 

dealer, seller, or reseller to purchase a

 

replacement lamp module. To replace

 

the lamp, follow the procedures in the

 

“Replacing the Projector Lamp Module”

 

section of Chapter 7.

 

 

8–6

Compaq iPAQ Microportable Projector MP1200 User’s Guide