HP NV15J185NR manual Hard drive

Reverse this procedure to install the WLAN module.

Hard drive

Description		Spare part number
1.5 TB, 5400 rpm, 9.5 mm (select models only)		747375-001
1 TB, 5400 rpm, 9.5 mm		676521-001
750	GB, 5400 rpm, 9.5 mm	634250-001
640	GB, 5400 rpm, 9.5 mm (for use on computer models with an AMD processor)	669300-001
500 GB 5400 rpm 9.5 mm		683802-001
1 TB, 5400 rpm, +8 GB NAND hybrid, 9.5 mm		731999-001
750 GB, 5400 rpm, +8 GB NAND hybrid, 9.5 mm		732001-001
500 GB, 5400 rpm, + 8 GB NAND hybrid, 7 mm		732000-001
256	GB SSD (for use on computer models with an Intel processor)	749761-001
512	GB SSD (for use on computer models with an Intel processor)	749762-001

Before removing the hard drive, follow these steps:

1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect the power from the computer by unplugging the power cord from the computer.

3.Disconnect all external devices from the computer.

4.Remove the battery (see Battery on page 41).

5.Remove the service door (see Service door on page 42).

Remove the hard drive:

1.Release the zero insertion force (ZIF) connector (1) to which the hard drive connector cable is attached, and then disconnect the hard drive connector cable (2) from the system board.

2.Release the hard drive connector cable (3) from the opening in the base enclosure.

46 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts