Checking the component code

If you have set up the remote control to use a component, you may need to find out which four-digit code is operating your component equipment:

1On the remote control, press CBL/SAT or DVD/VCR once.

2Press and hold SETUP until the red light blinks twice, then release SETUP.

3Press the number buttons 9, 9,1. The red light blinks twice.

4For the first digit of the code, press the number button 1 once. Wait 3 seconds, and then count the number of times the red light blinks and write down the number.

NOTE: When you count three blinks, it means the code digit is 3. When a code digit is 0, the red light will not blink.

5Repeat step 4 for the three remaining digits of the code, pressing 2 for the second digit, 3 for the third digit, and 4 for the fourth digit.

Reassigning component buttons

The remote control can be set up to control a second TV or VCR, or any combination of eight home entertainment components.

For example, to control a TV, a Cable Converter, and two VCRs, you need to re-assign a component button to operate the second VCR as follows:

1On the remote control, press and hold SETUP until the red light blinks twice, then release SETUP.

2Press the number buttons 9, 9,1. The red light blinks twice.

3Press DVD/VCR once, then press CBL/SAT once.

4The CBL/SAT button is now ready to be programmed for your second VCR. See “Programming the component code” on page 53.

To re-assign other device keys, repeat steps 1 through 4 by substituting the key sequence from the following table for the most popular components:

To assign

Use this sequence

 

 

 

TV as 2nd DVD/VCR button

SETUP - 9 - 9 - 2

— DVD/VCR - TV

 

 

 

TV as 2nd CBL/SAT button

SETUP - 9 - 9 - 2

— CBL/SAT - TV

 

 

 

TV back to TV

SETUP - 9 - 9 - 2

— TV - TV

 

 

 

 

VCR as 2nd CBL/SAT button

SETUP - 9

- 9 - 2

— CBL/SAT - VCR

 

 

 

 

VCR back to VCR

SETUP - 9

- 9 - 2

— VCR - VCR

 

 

 

 

CBL/SAT as 2nd VCR button

SETUP - 9

- 9 - 2

— VCR - CBL/SAT

 

 

 

 

CBL/SAT back to CBL/SAT

SETUP - 9

- 9 - 2

— CBL/SAT - CBL/SAT

 

 

 

 

When a re-assignment is done, the red light blinks twice to confirm your choice. Then, you need to program the remote control to control the new component; see “Programming the component code” on page 53.

54Using the TV