Changing volume lock

The remote control is set to control volume of a component through your TV while in the TV, DVD/VCR, or CBL/SAT mode. However, in the HP.PC mode you have separate control of the volume.

If you want the volume to be controlled by a different component than the TV, you can change the Volume Lock setting to control volume through a non-associated mode (e.g., through the cable in the TV mode).

To change volume lock to another mode:

1On the remote control, press and hold SETUP until the red light blinks twice, then release SETUP.

2Press the number buttons 9, 9, 3, and then press any mode key once (except TV). The red light will blink twice.

3Now, whenever you press VOL+, VOL–, or MUTE, volume is controlled by your component mode choice.

To change volume lock back to the TV mode:

1On the remote control, press and hold SETUP until the red light blinks twice, then release SETUP.

2Press the number buttons 9, 9, 3, and then press TV. The red light blinks twice.

3Now, whenever you press VOL+, VOL–, or MUTE on the remote control, volume is controlled by your TV.

Troubleshooting the remote control programming

Problem

Solution

 

 

Red light does not blink when you press

Replace the batteries with two (2) new AA non-rechargeable

a key.

batteries.

 

 

Red light blinks when you press a key, but

Make sure the remote control is aimed at your home

home entertainment component does not

entertainment component and is not farther than 15 feet away.

respond.

 

 

 

Remote control does not control home

Try all listed codes for the component brands being set up.

entertainment components or commands

Make sure they can be operated with an infrared remote

are not working properly.

control.

 

 

No volume on a 2nd TV.

Follow instructions in “Changing Volume Lock.”

 

 

CH+, CH– , and CH.RTN do not work for

Due to RCA design (1983–1987), only the original remote

your RCA TV.

control will operate these functions.

 

 

Changing channels does not work

If original remote control required pressing ENTER to change

properly.

channels, press ENTER on the Remote control after entering the

 

channel number.

 

 

Tried “Search Method” and still could not

Try the “Search Method” again after clearing out the component

find a working code.

button as follows: Press and hold SETUP until red light blinks

 

twice, then release. Next enter 9 - 9 - 2. Then press and release

 

the component button to be cleared twice.

 

 

Using the TV 55