Identifying the remote control buttons

Remote Control

Description

Item

 

 

 

Indicator light

The red light blinks once each time a button is

 

pushed. If the red light blinks two times when a

 

button is pushed, the remote control batteries are

 

low and need replacement.

 

 

Setup

Use the SETUP button when programming the

 

remote control for component control; see

 

“Programming the remote control for component

 

control“ on page 33.

 

 

PWR

Press PWR once to turn on or off the selected home

 

entertainment component.

 

 

TV, CBL/SAT,

Press one of these buttons once to select a home

DVD/VCR, or

entertainment component to control, and then point

HP.PC

the remote control at the component.

 

HP.PC selects the HP Media Center PC (connected

 

to the VGA or DVI connector) and enables the HP

 

MCPC special buttons on the remote. Refer to

 

“Using the HP MCPC with the TV remote control“ on

 

page 18 for more information.

 

To program the remote control to operate a cable or

 

satellite set-top-box or a DVD or VCR; see

 

“Programming the remote control for component

 

control“ on page 33.

 

 

Keypad

Use the keypad (0 ~ 9, +100) to directly select

 

channels.

 

 

Mute

Press MUTE once to turn sound off or on.

 

 

VOL

Use VOL+ (or VOL–) to raise (or lower) the sound

 

volume.

 

 

CH. RTN

Press CH. RTN (channel return) once to recall the

 

last channel or to page back one screen in the main

 

menu.

 

 

HP.MC

Press HP.MC to start Media Center when using the

 

HP Media Center PC.

CH

Use CH+ (or CH–) to select the next higher (or

 

lower) channel.

 

Selects TV as the input source.

 

 

Guide/P. Mode

Use GUIDE to display the program guide for a TV

 

set-top-box or for HP MCPC. Use Picture mode to

 

scroll through the three picture modes Standard,

 

Movie, or Dynamic.

EXIT/Back

Use EXIT to exit out of the selected component’s

 

menu or guide.

 

Use Back for the HP MCPC.

 

 

8Introduction