HP PL4260N 42 inch Plasma Turning On the TV, Turning the TV On and Off Standby, Power indicator

Turning On the TV

Turning the TV On and Off (Standby)

The TV has a Power button (A) on the front of the display. You can also use the remote control Power button to turn on the TV.

Pressing the Power button either turns the TV on or places it into standby, which is a reduced power state.

MENU
OK
+
VOL
–
+	A	B
CH
–
SRC

APower button and light

BRemote control sensor

The Power button includes an indicator light, which shows the power status of the TV.

Power indicator	Power status
Lights red	Standby (off)
Lights blue	Ready (on)
Off	AC power
	disconnected
Flashing red or	Start up diagnostics or
flashing blue	error

n

The initial setup starts when the TV powers on for the first time. If the TV has been turned on before, the Setup Wizard does not start. See “Starting the Setup Wizard” on page 40 to start the Setup Wizard from the System menu.

After the initial setup, the power-up time from standby depends on the Standby Mode setting:

■Low power, which consumes less power while in standby, uses approximately 20 seconds of power-up time.

■Fast power, which consumes more power while in standby, uses approximately 5 seconds of power- up time.

You can set the Standby Mode by using the System menu.

If the TV is not used for an extended period of time, press the Power button to place the TV into standby, and then unplug the power cord.

Using the TV buttons

1Press the Power button (A) on the front of the TV. The TV is on or in standby.

2Press SRC button to open the list of input sources. Press CH+ to select the input source to view, and press OK. Press SRC to close the list.

Turning On the TV

Turning On the TV 17