HP R100 VPN Router manual Run the wizard to set up the HP R110/R120

HP R100-Series Wireless VPN Routers Quickstart 5 Initial configuration

4.A Country prompt appears. Select the country in which the HP R110/ R120 is operating, and then click Save.

Caution: To ensure compliance, you must select the correct country. See Country of use on page 3.

The HP R110/R120 management interface home page opens.

4.Set the Connection Type for the WAN connection to your ISP. The default setting is to use the DHCP protocol. Click Next.

The management interface is organized with menus and sub-menus. Instructions for making menu selections, such as “select LAN

>Settings” indicate that you should select the LAN menu, and then the Settings menu.

Main menu

Sub-menu

D. Run the wizard to set up the HP R110/R120

1.Select Home on the management interface menu.

2.Select Start to start the wizard.

3.Either configure the system time manually by entering the date and time, or keep the default setting of Using network time protocol (NTP). Set the time zone for your region, and enable daylight saving, if required. Click Next.

5.Configure the wireless settings:

•Select the 2.4 GHz or 5 GHz radio band for your wireless network.

(The HP R120 has separate settings for the 2.4 GHz and 5 GHz bands.)

•Set the radio operating mode. Select a compatibility mode if support for older 802.11a/b/g devices is required, otherwise HP recommends that you select either 11n only or 11ac only.

•Set a unique SSID name for the wireless network.

•Select an authentication mode for security. In this example, a setting of WPA2-PSKis selected and a Passphrase is entered for the network security. For information on other wireless security settings, see the HP R100-Series Wireless VPN Routers Configuration/Administration Guide.

Click Next.