4 Setting Up and Using the Scanner

Follow the steps below to connect and get the scanner up and communicating with its host.

1.Connect the Cable to the scanner and the Host.

2.Configure the Interface (refer to Configuring the Interface on page 9).

3.Configure the scanner as described in Programming the Scanner on page 15 (optional, depends on settings needed).

Connect/Disconnect Cable to Scanner

Figure 4-1Connecting to the Scanner

Figure 4-2Connecting to the Host

Host Connection: The scanner plugs directly into the host device as shown above.

8 Chapter 4 Setting Up and Using the Scanner

ENWW