Assembling the Stand

To assemble the components of the stand, refer to the Figure 4-9 (Figure 2) below.

Figure 4-9Stand Assembly

1.Place the metal Base Plate (2) and the Base Cover (3) together with the countersink in the Base Plate facing out.

2.Place one of the flat-head machine screws (1) through the Base Plate (2) and Cover (3).

3.Screw the Flex Tube (4) to the Base Plate (2) and Cover (3) making sure the notch in the Flex Tube (4) aligns with the ribs in the Base Cover (3) as shown in Figure 4-9 (Figure 3). Tighten firmly.

4.Place the Flex Tube Cover (5) over the Flex Tube (4).

5.Screw the Cup (6) to the Flex Tube using the second flat-head machine screw (1) making sure the notch in the Flex Tube (4) aligns with the ribs in the Cup (6) as shown in Figure 4-9 (Figure 4). Tighten firmly.

6.Select the appropriate bar code label [Laser or Imager (8)], peel off the backing and affix to the recess in the Base Cover (3).

Installation

Attachment with screws:

1.Make sure that the stand is properly assembled.

2.Fix the base of the stand to the desired surface with the three screws provided (7).

3.Adjust as needed.

ENWW

Installing the Stand 13