HP t5135 manual Replacing the battery, Removing the side access panel and metal side cover

Replacing the battery

Before beginning the replacement process, review General hardware installation sequence for procedures you should follow before and after installing or replacing hardware.

To replace the battery:

1.Remove the side access panel and metal side cover

2.Remove and replace the battery

3.Replace the metal side cover and side access panel

Removing the side access panel and metal side cover

WARNING! Before removing the side access panel, ensure that the thin client is turned off and the power cord is disconnected from the electrical outlet.

To remove the access panel:

1.Remove the secure compartment cover (1). For more information, see Removing the secure USB compartment cover.

2.Remove the two back panel screws that secure the access panel to the chassis (2).

3.Slide the access panel about 1/4–inch toward the front of the unit, and then lift the access panel up and off the unit (3).

Figure 2-4Removing the side access panel

To remove the metal side cover:

1.Remove the three screws that secure the metal side cover to the chassis (1).

12 Chapter 2 Hardware changes ENWW