Installation instructions
Water supply
7
EN
This washer must be plumbed into both a hot and cold water supply or it will not work correctly. Please ensure that both hot and cold water are connected to the washer.
If you have an uncontrolled
Inlet Water Static Pressure 3psi (20kPa) to 150psi (1MPa) (If using a header tank then the top of the header tank must be at least 39” (2 m) above the top of your clothes washer).
Minimum flow rate from the faucet supplying the clothes washer should be greater than 1 ½ gallons/min (6 liters/min) (assumes ½” (12.7 mm) diameter pipes).
Minimum height of faucets to clear the top of the washer is 45” (1150 mm).
Draining
Regularly check that your standpipe or set tub/sink is free from lint or other obstructions, which may affect how your washer works or may cause flooding.
In
Clothes washer safety
This clothes washer is not intended for use by young children or infirm persons without supervision.
Please supervise young children to ensure they do not play with this clothes washer.
Important!
If you are using an extension cord or a portable electrical outlet device (eg.
Accessories and spare parts
Available from your Fisher & Paykel Dealer or Authorized Service Center.
Drain Hose Extension | Part No. 425627p |
Power Cord | If the Power Cord of your clothes washer is damaged it must be |
| replaced by a Fisher & Paykel Authorized Service Center, as it |
| is not a standard power cord. |
