●Fan (see Fan on page 63)
●Heat sink (see Heat sink on page 64) Remove the system board:
1.Disconnect the Bluetooth module cable (1) from the system board.
2.Release the ZIF connector to which the power switch board cable is connected, and disconnect the power switch board cable (2) from the system board.
3.Remove the four Phillips PM2.5×4.0 screws (1) that secure the system board to the base enclosure.
4.Remove the two Phillips PM2.5×4.0 screws (2) that secure the power connector to the base enclosure.
5.Release the power connector (3) from the base enclosure.
6.Use the hard drive connector (1) to lift the right side of the system board (2) until it rests at an angle.
60 Chapter 4 Removal and replacement procedures | ENWW |
