HP UX System Management Software GUI, tar, tar, tape, tape, SWAP, SD-UX, 0xLLA, bundle, server, server, subnet, server, server, SCRIPTS, bundles, (SD-UX), SYSCMDS, archive, archive, Software

S
save_config	An Ignite-UXcommand that creates a hardware configuration file. It extracts disk and file system
	information along with certain system and networking parameters for the current system, and
	writes it to a configuration file. See save_config(1M).
script hook	Predefined mechanisms allowing user-defined scripts to run at specific points during the
	execution of the installation. Within the Ignite-UX installation procedure there are various script
	hooks: pre-config, pre-load, post-load, post-config, and final. See instl_adm(4) under “Command
	and Script Execution Hooks.”
SCRIPTS	A configuration clause of commands in the LIF volume containing scripts that can be selected in
	the itool under the Advanced tab.
SD-UX	See Software Distributor.
selectable	For 11i v1 and 11i v2, software bundles that are not installed by default with HP-UX. You must
	select these bundles to install them. Ignite-UXis an example of a selectable software bundle.
server	A computer that provides software and services to clients.
setup_server	An Ignite-UXcommand that performs administration tasks for an Ignite-UX server from a
	command line interface. The same functionality is available with the Ignite-UX GUI. See
	setup_server(1M).
Software Depot	See depot.
Software	An HP-UX product that provides a set of tools for centralized HP-UX software management.
Distributor	SD-UX commands are included with the installation of the HP-UX operating system. SD-UX
(SD-UX)	commands typically use the prefix “sw”, such as in swinstall and swverify.
stand alone	In terms of Ignite-UX(as opposed to any other usage) a client system that is not network booted,
	but may still use an Ignite-UX server for installation or recovery.
standard label	A tape containing ANSI standard labeling. Ignite-UX uses ansitape(1) to create a standard label
tape	tape.
subnet	A separate part of larger a network connected via network gateways.
SWAP	A use designation typically for an LVM logical volume or a VxVM volume for paging. See
	swapon(1M).
SWAP+DUMP	A use designation typically for an LVM logical volume or a VxVM volume that can be used for
	DUMP or SWAP.
SYSCMDS	A compressed tar archive of commands in the LIF volume or on an Ignite-UX server, required
	for installation of PA-RISC systems.
SYSCMDSIA	A compressed tar archive of commands in the LIF volume or on an Ignite-UX server, required
	for installation of Itanium-based systems.
system image	See image.
system recovery	The use of a recovery image to reestablish a system.
Symbols and numbers
0xLLA	See Link Level Address
T
terminal user	A method of interacting with computers that employs a character-based display that works on
interface (TUI)	non-graphical terminals. The TUI uses a keyboard for navigation, not a mouse.
two-step media	A method of using the Ignite-UXtape recovery tool when a system or I/O interface does not
recovery	support firmware tape boot. The method involves step 1: booting from installation media such
	as DVD or CD, and then step 2: recovering from tape.

40 Glossary