Troubleshooting
|
| Possible | Recommended | |
Activity | Beeps | Cause | Action | |
|
|
|
|
|
Red Power LED | None | Power failure | 1. | Check that the voltage |
blinks once every |
| (power supply |
| selector, located on the |
two seconds. |
| is |
| rear of the power |
|
| overloaded). |
| supply, is set to the |
|
|
|
| appropriate voltage. |
|
|
|
| Proper voltage setting |
|
|
|
| depends on your |
|
|
|
| region. |
|
|
| 2. | Open the hood and |
|
|
|
| ensure the |
|
|
|
| power supply cable is |
|
|
|
| seated into the |
|
|
|
| connector on the |
|
|
|
| system board. |
|
|
| 3. Check if a device is | |
|
|
|
| causing the problem by |
|
|
|
| removing ALL attached |
|
|
|
| devices (such as hard, |
|
|
|
| diskette, or optical |
|
|
|
| drives, and expansion |
|
|
|
| cards.) Power on the |
|
|
|
| system. If the system |
|
|
|
| enters the POST, then |
|
|
|
| power off and replace |
|
|
|
| one device at a time |
|
|
|
| and repeat this |
|
|
|
| procedure, until failure |
|
|
|
| occurs. Replace the |
|
|
|
| device that is causing |
|
|
|
| the failure. Continue |
|
|
|
| adding devices one at |
|
|
|
| a time to ensure all |
|
|
|
| devices are functioning |
|
|
|
| properly. |
|
|
| 4. | Replace the power |
|
|
|
| supply. |
5. Replace the system board.
www.hp.com | Getting Started Guide |
