FA 500.2
8. Malfunctions
Check the following before calling customer service:
•Is the power plug connected?
•Is the shredder switched on?
•Is there a paper jam in the shredder?
•Has the motor been overloaded?
Paper jam
You have fed in too much paper.
`The red LED on the keypad blinks.
`The cutting block automatically runs in reverse for several seconds.
Caution!
The blade rollers can still cause injuries even while they are not running.
Do not reach into the cutting apparatus! Wear safety gloves!
•Take out the pile of paper.
•Press the green start button and put less paper on the feed belt.
Electric motor overheated
` The red LED on the keypad lights up.
`The shredder switches off automatically.
•Let the motor cool down for 20 - 30 minutes
• Press the green start button.
Safety circuit interrupted
`The red LED on the keypad lights up.
`The shredder switches off automatically.
•Check
-Safety flap on the feed belt is closed.
-The dust tray is pushed in completely.
-(only stand
-(only stand
The protective flap is in vertical position.
• Press the green start button.
9. Maintenance and care
Cleaning the cutting unit if the cutting quality deteriorates or the machine becomes noisy
•Let the shredder run without feeding in any paper.
•Push the lever of the oiler down several times.
•Make sure the oil level in the container is between the MIN and MAX markings. Order no. 1.235.997.500 for
MAX 5 litre container
MIN
Emptying the dust tray
Paper dust and particles accumulate in the paper shred- der during operation. To facilitate cleaning, the ground plate of the paper shredder was designed as a tray. This tray must be emptied every week.
Note:
The paper shredder cannot be switched on unless the dust tray is fully pushed in.
10 | 0702 |
