HTC 2 Installing the Battery and Storage Card, To remove the back cover, To install the battery

18  Getting Started

1.3  Installing the Battery and Storage Card

You need to remove the back cover before you can install the battery and storage card. Also, make sure to always turn off the power before installing or replacing the battery.

To remove the back cover

1. Make sure your device is turned off.

2.Remove the stylus.

Note You need to temporarily remove the stylus to be able to remove or replace the back cover.

3. Firmly hold the device with both hands and the front panel facing down.

4.Push the back cover up with your thumbs until it disengages from

the device and then slide it up to remove.

Battery

Your device comes with a rechargeable Lithium-ion battery and is designed to use only manufacturer- specified original batteries and accessories. Battery performance depends on many factors, including network configuration, signal strength, and usage patterns. For battery life estimates, see “Specifications” in the Appendix.

Warning! To reduce risk of fire or burns:

•Do not attempt to open, disassemble, or service the battery pack.

•Do not crush, puncture, short external contacts, or dispose of in fire or water.

•Do not expose to temperatures above 60°C (140°F).

•Replace only with the battery pack designated for this product.

•Recycle or dispose of used battery as stipulated by local regulations.

To install the battery

1.Align the battery’s exposed copper contacts with the battery connectors at the bottom part of the battery compartment.

2. Insert the contacts side of the battery first and then gently push the battery into place.

3. Replace the back cover and insert the stylus back
into the stylus compartment.	Groove

To remove the battery

Lift out the battery from the groove at the upper right side of the battery compartment.