TRIAMP MK II - MANUAL
REAR
MAINS IN: Socket for the included Euromains power cable. Before plugging into the wall socket, make certain the amp's voltage rating as dis- played in the VOLTAGE SELECTOR window matches your local AC voltage rating.
VOLTAGE SELECTOR: If you need to change TriAmp® MK II's voltage to your local AC voltage rating, pull out this cartridge and see Section 2.1 for further details.
ANODE FUSE: Fuse holder for the power amp's anode fuses. Be sure you only use fuses rated to the indicated specifications.
HALF POWER: This power soak switch cuts the TriAmp® MK II’s output power in half from 100 watts to 50 watts.
PREAMP OUT, POWER AMP IN: The TriAmp® MK II sports an ancillary serial FX loop that lets you control master volume via a volume pedal.
The preamp signal is patched out via PREAMP OUT jack and in again via POWER AMP In.
STAGEBOARD: Input jack for TriAmp® MK II STAGEBOARD. The length of the cord can be extended using standard computer cables (equipped with
FX LOOP
FX SERIAL/PARALLEL: An innovative new feature of the TriAmp® MK II, it lets you select the desired type of effects loop, parallel or serial, at the touch of a button. The FX loop setting may be stored and switched via MIDI using the optional
LEVEL: Determines the relative levels of the TriAmp® MK II’s preamp signal and the signal routed into the FX RETURN jack as sent from a connected effects device and the like. In other words, use it to set the desired wet/dry mix.
FX SEND: Connect this jack to your effects processor's input jack.
FX SEND LEVEL: This damping switch allows you to adapt the signal level to
FX RETURN: Connect this jack to your effects processor's output jack.
RED BOX® DI OUT: This is a balanced output featuring the RED BOX® Cabinet Simulator.
It enables you to feed the TriAmp® MK II signal directly to a mixing console for stage and recording purposes. Refer to Section 4.3 for details.
SPEAKER: The TriAmp® MK II features
NOTE:
Never operate the TriAmp® MK II without a loudspeaker connected!
8
